| We are including our complete specifications
below for Architects who want to specify our Original PGA approved
Lundia Golf Bag Storage Systems. You are welcome to copy this
information for your own use.
Specifications:
Lundia Golf Bag Storage System
Shelves are to be manufactured of 3/4" edge-glued and
finger-jointed pine.
All shelf materials are to be machined to accept roll formed aluminum
extrusions shaped to fit into a routed slot on the end of the shelf and to rest on the
shelf support pins. End channels are to be flush with our below shelf
faces.
Typical shelving sizes are 15"deep x 42"wide unless noted otherwise.
Uprights are to be manufactured from clear, solid hemlock or
Douglas fir. Two 1-5/16" x 1-5/8" stiles are to have a 3/8" wide x 5/8"
deep plow the entire height to receive shelf end channels and are to be
drilled with 3/16" diameter holes on 2" centers to allow for shelf
adjustability. Stiles are to be locked together with two or more cross
members mortised into the stiles. All components are to be machined
smooth with all outside corners eased.
Backs and/or sides to be closed with Hardboard panels or optional
HPL laminated surface panels.
Mobile Track is required under all wheel channels. Track is to be
.624"high with 45 degree bevels on both sides to prevent tripping during
use. Top three sides are serrated to prevent marring. Two rolls of
C-1095 blue tempered spring steel hardened to 56 Rockwell C scale
inserted into the housing to act as a riding surface for the wheels. The
inserts are held in place by .043" flanges on both sides. Two .187"
hardened roll pins hold any/all splices together with a 1"inset in both
sides of the splice.
Carriage frames to support shelving and allow movement along the
track are extruded 6063-T6 aluminum. The standard rail is 2" x .125"
serrated two sides to prevent marring. The rail for the shaft driven
carriage is 3 1/4" x length of the carriage section as specified on
layout. The channel is 1.875" x 1.125" with .375 solid legs for maximum
load bearing without distortion. The corners are minimum 3" x
.125" with a 1" lip above the carriage surface. The mid-plates are 3" x
3" square. Both pieces have a black enamel baked finish.
Wheels are 6063 permanently sealed, self-lubricating, high
revolution bearing. Static load bearing capacity is 1,430 lbs. per
wheel.
Optional Mechanical Assist Systems are front driven on carriages over
8'long but under 16'long where the overall weight does not exceed 20
tons. Seven turns of the handle are required to access a 36" aisle.
System only requires 1 lb. of pressure to move 1,000 lbs. of golf bag
storage.
Factory contact information:
LundiaUSA / The Recom Group
Phone in USA: (888) 989-1370 International: (909) 599-1370
449 Borrego Court, San Dimas, CA 91773
www.LundiaUSA.com |
